TESTO Saveris H2E - Configuring Hardware

6 Commissioning
41
26
Press the [Connect] key on all data loggers and Saveris routers one
after the other to synchronize the components.
27
Close the dialogue with [OK].

The hardware is now ready for operation.
For how to mount the hardware on the wall for example, see section
6.10.3 Wall mounting of data loggers
.
6.9 Configuring hardware
Use the installation instructions for the initial commissioning of the system.
The following requirements must be fulfilled for the rest of the hardware
commissioning process:

The Saveris base is ready for operation.

All data loggers are registered on the Saveris base.

The Saveris software is installed.

A project has already been created.

Measurement operation has been ended.
1
Connect the Saveris base via the USB or network cable to a computer
on which the Saveris Client is installed.
For continuous operation of the system, connection of the Saveris base
to the computer via an Ethernet cable is recommended.

The startup wizard is launched.
2
Click on [Next >].