s
EN
The appliance is equipped with various safety features which monitor the operation of the system.
In the event of malfunction, a controller automatically deactivates the function currently in use.
The type of error detected is shown on the bottom line of the display.
Certain kinds of trouble can be rectified without calling in a technician; the following table indicates the action to take when
a function locks up.
If the display indicates a fault other than those mentioned in the table, the system needs to be RESET as follows:
- isolate the appliance from the power supply
- reconnect power after a few seconds
- select the function which locked up previously.
If the fault persists, call the nearest Teuco Authorized Service Centre (see list attached).
CAUSE
Waterlight prevented from starting up due to
insufficient water in tub.
Disinfection cycle prevented from starting due to
insufficient liquid in dispenser.
Suction valve blocked.
ACTION
Fill the tub with water to the minimum level allowing the
function to self-activate
Replenish the dispenser with liquid disinfectant supplied
by Teuco.
Clean the suction valve (see maintenance heading).
TROUBLE OR FAULT
ADD WATER
ADD
DISINFECTANT
LOW PRESSURE
REPAIRS
If any part of the appliance fails to operate as it should, call the nearest Teuco Authorized Service Centre (see list
attached).
DIAGNOSTICS MESSAGES
To Next Page
Loading...
