10
SEASIDE
EN
BLOWER function
Special whirlpool essences made by Teuco can be used
when the Blower is in operation.
Do not use soaps, bath oils or other foamable products.
STARTING THE BLOWER
Pressing the “O/I” button to switch on,
the display goes into READY mode.
Display indicating READY
status
3 6 ° C 2 0 : 3 0
R E A D Y
Press the “BLOWER” button to activate the function.
Display indicating READY
status
3 6 ° C 2 0 : 3 0
R E A D Y
When the Blower has finished, the system shuts off and the
display reverts to READY.
To cut the session short, press the BLOWER button a second time; the system shuts off and the display reverts to
READY.
The Blower starts and the display shows:
The exact time.
The temperature of the water in the tub.
The duration of the blower session (TIMER) in minutes (adjustable).
Blower in progress.
Display indicating Blower
in progress
1 5 3 6 ° C 2 0 : 3 0
B L O W E R
DRAINING THE BLOWER SYSTEM
To ensure the blower system drains completely, activate the BLOWER function after the tub has emptied so as to
dry out the pipelines.
Also,
15 minutes after unplugging the waste, the control panel will power up again; the BLOWER function starts up at
maximum speed, then switches off after 10 seconds (control panel reverts to stand-by).
To Next Page
Loading...
