SEASIDE
13
EN
WATERLIGHT function
STARTING THE WATERLIGHT
Pressing the “O/I” button to switch on,
the display goes into READY mode.
Display indicating
READY status
3 6 ° C 2 0 : 3 0
R E A D Y
Special bath essences made by Teuco can be used
when the waterfall is in operation.
Do not use soaps, bath oils or other foamable products.
Press the “WATERLIGHT” button to activate the function.
The function starts up and the display shows:
The exact time.
The temperature of the water in the tub.
The duration of the session (TIMER) in minutes (adjustable).
Waterlight in progress.
Display indicating
Waterlight in progress
3 0 3 6 ° C 2 0 : 3 0
W A T E R L I G H T
Display indicating
READY status
3 6 ° C 2 0 : 3 0
R E A D Y
When theTimer setting elapses, the system shuts off and the
display reverts to STAND-BY.
To cut the session short, press the WATERLIGHT button a second time; the system shuts off and the display reverts
to READY.
If the message “ADD WATER” is displayed, fill the tub to the
level at which the selected massage is able to start.
FUNCTION DOES NOT START!!!
Display in
DIAGNOSTICS mode
A D D
W A T E R
To Next Page
Loading...
