Teuco Seaside - Page 9

AUTOMATIC SHUTOFF:
If no control panel or remote control button is pressed within 30 minutes following power-up or since the last function
was active (TIMER setting) the system shuts off and the display reverts to STAND-BY.
DISINFECTION of the system is not carried out (see DISINFECTION).
To switch on, press the “0/I” button;
the welcome message will appear in the control panel display
for a few seconds.
Thereafter,
the display switches to READY;
the system can now be used
(see WATERLIGHT or BLOWER).
To switch off the panel, press “0/I” a second time:
if no cycle has been selected, whether Waterlight or Blower,
the system shuts off and the display reverts to STAND-BY.
if if at least one cycle has been selected, whether Waterlight
or Blower, a message will be displayed prompting
DISINFECTION (see DISINFECTION).
Display showing
Disinfection prompt
S T A R T
D I S I N F E C T I O N ?
W E L C O M E T O
S E A S I D E
Display indicating
READY status
3 6 ° C 2 0 : 3 0
R E A D Y
Display in STAND-BY mode
2 0 : 3 0
SWITCHING ON FROM THE REMOTE CONTROL
SEASIDE
9
EN