Teuco Seaside - Quick Start Function; Alarm Function

SEASIDE
7
EN
QUICK START
Once the system has been powered up, the Waterlight (illuminated waterfall), Sunlight and Moonlight functions can be
activated by pressing a single button at the control panel.
Display in STAND-BY mode
2 0 : 3 0
To make adjustments, use the remote control
(see REMOTE CONTROL).
To start the functions, press the “QUICK START” button.
The functions start and the display shows:
The exact time.
The temperature of the water in the tub.
The duration of the function (TIMER) in minutes.
Waterlight in progress.
Display indicating Waterlight
in progress
3 0 3 6 ° C 2 0 : 3 0
W A T E R L I G H T
Display indicating Waterlight
in progress
3 0 3 6 ° C 2 0 : 3 0
W A T E R L I G H T
When theTimer setting elapses, the system shuts off and the display reverts to STAND-BY.
DISINFECTION of the system is not carried out (see DISINFECTION).
To cut the function short press QUICK START a second time or use the remote control (see REMOTE
CONTROL:Preliminary operations); the system shuts off and the display reverts to STAND-BY.
ALARM
The ALARM can be activated directly from the control panel.
The alarm locks up the system, shutting off any functions currently selected, and can also activate a bell or other sounder,
provided that this is already installed (see directions for installing the tub).
Display in STAND-BY mode
2 0 : 3 0
Display indicating “ALARM”
status
A L A R M
To activate the alarm, press the “ALARM” button.
To reset the system, press the QUICK START button or the
I/O button on the remote control;
the display reverts to STAND-BY mode and the system
shuts off.