Texas Instruments INA228 User Manual

LOGO
PCB
Texas Instruments
FID2
DNP
FID1
DNP
FID3
DNP
SENS063
B
PCB Number:
PCB Rev:
Label Assembly Note
ZZ1
This Assembly Note is for PCB labels only
Assembly Note
ZZ2
These assemblies are ESD sensitive, ESD precautions shall be observed.
Assembly Note
ZZ3
These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable.
Assembly Note
ZZ4
These assemblies must comply with workmanship standards IPC-A-610 Class 2, unless otherwise specified.
Variant/Label Table
Variant Label Text
001 INA228EVM
002 INA237EVM
CE Mark
LOGO
PCB
FCC disclaimer
LOGO
PCB
WEEE logo
Size: 0.65" x 0.20 "
PCB Label
LBL1
THT-14-423-10
LOGO5
DANGER HIGH VOLTAGE
LOGO6
CAUTION HOT SURFACE
003 INA238EVM
MECH
H5
SENS077
MECH
H6
6612041
H2
SJ5382
H3
SJ5382
H1
SJ5382
H4
SJ5382
Assembly Note
ZZ5
Trim the leads under J1 (back of PCB) to give clearance from surface
Figure 6-2. SENS063 Hardware Schematic
www.ti.com Schematics, PCB Layout, and Bill of Materials
SBOU241C – APRIL 2020 – REVISED JULY 2021
Submit Document Feedback
INA228, INA229, INA237, INA238, and INA239 EVM User’s Guide 23
Copyright © 2021 Texas Instruments Incorporated

Texas Instruments INA228 Specifications

General

Brand	Texas Instruments
Model	INA228
Category	Motherboard
Language	English