RadioShack parts list for BCC deluxe
18.57Total cost:
0.15278-13104-conductor 24GA solid
phone cable, 1 foot
Hook-up wire
1.99274-2453/32" female jack
1.4964-30184-40 hex nuts
1.4964-30114-40 machine screws
2.19276-138110 mmStand-offs
2.29270-18024" x 2" x 1"Enclosure
1.29276-1538CDB9 female connector
1.19276-150Printed-circuit board (PCB)
0.49276-1342 (pack of 5)47kohm, 1/8W, 10%R5, R6
0.49276-1347 (pack of 5)100kohm, 1/8W, 10%R1, R2, R3, R4
2.36276-2023PN2907Q3, Q4, Q6, Q7
1.96276-20582N4401Q1, Q2, Q5, Q8
1.19276-1122 (pack of 10)1N914/1N4148D1, D2, D3, D4
Total cost US$RadioShack part numberValueDesignator
All of these parts should be in stock at any RadioShack, but your particular RadioShack may have to
order some of them. Also, prices may vary slightly from store to store. The 4-40 machine screws and
nuts are used to mount the DB9 connector to the enclosure. The individual wires of the phone cable
are used for jumper wires on the PCB. Considering that the component cost is about $19, and you can
buy the TI cable for $20, you aren't saving much money. However, much of the cost is in the enclosure
and mounting hardware. You can save some money by using creative alternatives.
This figure shows one possible component layout on the 276-150 PCB:
5 - 7
To Next Page
Loading...
Need help?
General
