To Next Page

To Previous Page

then the expression results in a dialog box like this:

what?:

and the string that the user enters will be stored in myvar. The value of this approach is that the actual

prompt string and variable name can be stored in promptn and vname by preceding code, then the

single expr() executes the dialog box. In other words, you can change the contents of a dialog box as

needed, depending on run-time conditions.

This idea can be extended to all functions that can be used in a dialog box: Text, DropDown, and Title,

in addition to Request. The basic principle is to build the complete Dialog ... EndDlog block up as a

string. Each program line is separated by ":".

This dialog box demonstrates the use of all four dialog box functions.

To explain each option, as well as make it easier to build the dialog box, I have defined these functions:

dbttl(): Dialog box title (Title)

dbreq(): Dialog box request (Request)

dbdrd(): Dialog box drop-down menu (DropDown)

dbtxt(): Dialog box text string (Text)

dbend(): Terminate the dialog box string

These are the steps you use in your program to create the dialog box:

1. Initialize a string variable to start building the dialog box string

2. Call the four functions above, as needed, to make the dialog box you want

3. Terminate the dialog box string

4. Display the dialog box with expr()

The code shown below creates my dialog box example.

dbdemo()

Prgm

local promptn,vname,boxtitle,sometext,ddtitle,dditems,ddvar,dbox

"what number?"→promptn

"myvar"→vname

"BOX TITLE"→boxtitle

9 - 7

Texas Instruments TI-92+ User Manual

Questions and Answers: