EasyManuals Logo
Home>Texas Instruments>Calculator>TI-nspire CX CAS

Texas Instruments TI-nspire CX CAS User Manual

Texas Instruments TI-nspire CX CAS
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
101
Both handhelds
“Transfer failed. Check cable and try
again.“
OK
The sending and/or receiving handheld is not
properly connected. Reinsert the cable into each
handheld, and then try the transmission again.
Receiving
handheld
“You are receiving an OS Upgrade. Unsaved
changes will be lost.
Would you like to continue?“
Yes No
This message is displayed when an OS Upgrade is
about to begin. If you do not select Yes within 30
seconds, the system automatically responds with
No.
Receiving
handheld
“Receiving OS. Do not unplug cable.“
This message, along with a progress bar, is
displayed while the OS Upgrade is being
transferred.
Receiving
handheld
“Installing OS.“
This message is displayed when the transfer is
complete. It is shown to keep you informed of the
handhelds status.
Receiving
handheld
“OS has been installed. Handheld will
restart.“
OK
This information message displays briefly before
the handheld automatically reboots.
Receiving
handheld
“Install was corrupted. Handheld will
reboot. You will need to retry OS upgrade.“
OK
An error occurred during the transmission and the
installation was corrupted. The handheld will
reboot. After the reboot, reinstall the OS Upgrade.
Shown on: Message and Description

Table of Contents

Other manuals for Texas Instruments TI-nspire CX CAS

Questions and Answers:

Texas Instruments TI-nspire CX CAS Specifications

General IconGeneral
BrandTexas Instruments
ModelTI-nspire CX CAS
CategoryCalculator
LanguageEnglish

Related product manuals