76 Configuring Handhelds
Attaching a Wireless Adapter to a CX Handheld
The TI-Nspire™ CX Wireless Network Adapters work with the TI-Nspire™
CAS and TI-Nspire™ CX CAS handhelds. The battery in the TI-Nspire™ CX
handheld powers the wireless adapter. To connect the handheld to the
wireless adapter:
1. Position the wireless adapter on top of the handheld so the connector
on the adapter lines up with the connector on top of the handheld.
2. Slide the adapter into position, making sure the guides on the sides
of the adapter slide into the grooves on the sides of the handheld.
3. Firmly press the adapter into place so that the adapter sits on top of
the handheld as shown in the following illustration.
Wireless network adapter (school-owned)
Connector
Guides for
aligning with
handheld
Sideview of handheld
Groove to align
wireless adapter
To Next Page
Loading...
