Ricochet MT2 Addendum
10 ADD068
Wintex Changes
Several changes have been made to Wintex™ to accommodate the new Ricochet™ MT2 technology, and the panel firmware upgrade.
Wintex™ can now act as a server for Ricochet Monitor™. This allows for a single connection to the control panel to view data in both
Wintex & Ricochet Monitor.
When connected to Ricochet™ Monitor through Wintex,™ all Wintex™ operations are suspended.
When using Ricochet ™Monitor through Wintex™ care should be taken regarding the method used to connect. There may be a
significant loss of performance when trying to view Ricochet™ Monitor over PSTN or GSM connections. Local, GPRS and IP
connections are recommended.
Account Information
Panel Details
Two new tick boxes have been added
• Include All Radio Config when Sending Data
• Include All Ricochet Config when Sending Data
These two boxes are only relevant for SENDING data back to
the panel, by default they are switched of as all data can be
RECEIVED from the panel.
Setup
Modem and Settings Information TCP/IP
On this Tab a new option has been added for Ricochet™
Monitor to define the Port number used to connect to
Ricochet™ Monitor. This number must be the same as the
one used in Ricochet™ monitor for the site you are
connecting to, and the enabled box must be ticked.
Zone Details
Zone List
Each Ricochet zone shows the zone number, expander and
device slot being used.
The wiring type information on the main screen is replaced
with the device mode.
Ricochet Device Mode
The wiring type dropdown box is replaced by a Device Mode
dropdown box.
Ricochet™ Device Type
The Ricochet™ Device type is shown at the bottom of the
page.
Premier Elite SmartKey™
Premier Elite SmartKey™ is shown on the User page. For
each User who is assigned a Premier Elite SmartKey™ the
following will be shown detailing the expander it is learmed to,
the slot it occupies and the status of the LED and Aux
functions.
Ricochet Monitor Launch & Connect
A new button has been added to Wintex™ to launch and
connect to Ricochet™ Monitor. The button will only work
when you are connected to the control panel through
Wintex™.
Not Connected to Panel
Connected To Panel
Connected to Panel & Ricochet Monitor
To Next Page
Loading...
