Premier 24, 48, 88, 168 & 640
To assign a Proximity TAG to a User, proceed as follows:
1. Program the User code as normal, this new option will now appear at the end :-
‘Do you want to Add TAG to User?’
2. Press
3. Present the Proximity TAG to the keypad within 10 seconds.
4. A confirmation tone will be heard, the TAG is now programmed.
The Premier keypad is only compatible with Texecom Premier control panels.
General Operation
1. A Proximity TAG must be held over the PROX symbol on the keypad.
2. A Proximity TAG will normally work at distances of up to 4cm, however it should be
noted that distances can and do vary.
3. Presenting a Proximity TAG to the keypad is NO different to entering a code
except that it is a SINGLE action as opposed to a MULTIPLE action.
4. The control panel will log which User/TAG has been presented.
Programming Proximity TAGS
Programming a Proximity TAG will depend on which type of control panel and what
version of software is installed (this can normally be obtained from the sticker on the
Microprocessor or by viewing the ‘Version No’ in the relevant control panel menu).
The indicated method of programming should always be used when assigning new or
additional TAGS to the system.
Care Instructions
• Clean keypad using a dry cloth.
• Do not use detergents with this product.
1. Introduction
Determine your Panel Type
From Day Mode press followed by 4, the keypad will display the model and
software version. Note which model you have and proceed as follows:-
Operation
2
GB
Programming
INS525-2
To Next Page
Loading...
Need help?
General
