4 INS165
Selecting an Address
Each keypad MUST be given a different address using the DIP
switch on the PCB as follows:
Address
DIP 1
DIP 2
DIP 3
DIP 4
1 N/A Off Off Off
2 N/A Off Off On
3 N/A Off On Off
4 N/A Off On On
5 N/A On Off Off
6 N/A On Off On
!
"
NEVER set two RKPs to the same address.
Keypads are factory set to address 1.
If the keypad is powered but offline (i.e. T and R not
connected) it will display its address.
If an invalid address is selected, the keypad will sound an
error tone
To Next Page
Loading...
