INS165 5
Configuring The Keypad
When the system is powered up it automatically checks and
configures all connected keypads. It is strongly recommended that
the system is completely powered down (mains and battery) before
wiring a keypad. If a keypad is added without removing power then
it must be configured as follows:
From the unset state:
Enter your Engineer code
!!!!
!!!!!!!!
!!!!
Press
"
""
"
to access the Programming Menu
Enter
#$
#$#$
#$
to select the Configure RKPs option
Press
"
""
"
, the system will chime & scan for RKP addresses 1 - 6
Press
%
%%
%
to return to the Programming Menu
Press
%
%%
%
to return to the unset state
!
"
If an RKP is configured but off-line the system will have a
tamper fault.
To Next Page
Loading...
