Texmo Industries Taro Pumps SVSM Series - Flooded Suction Installation; Motor Filling Procedure

SVSM products are prefilled with pure drinking water
and dispatched from the factory. TSSM and SSM
products shall be filled with pure drinking water before
installation. For SSM and TSSM products (Fig. 6a and b),
unscrew plugs 1 and 2, fitted on top of the motor and
fill up the motor with pure drinking water. For SVSM
products, in case the motor is not full, top up the motor
with pure drinking water, as illustrated below in Fig. 6c.
Gently rock the motor to release air bubbles and further
top up if necessary. Then replace the two plugs.
Fig. 6 Filling the motor of single phase openwell
submersible monoblock with pure drinking water
Prior to installation, unscrew the Brass Plugs 1 and 2,
fitted on top of the motor as shown in Fig. 5 below,
and fill the motor with pure drinking water till water
overflows from the other filling hole. Gently rock the
motor to release air bubbles and further top up if
necessary. Then replace the two plugs.
Fig. 5 Single phase openwell submersible
monoblock with flooded suction
DELIVERY
PIPE
MIN WATER
LEVEL
WELL
POWER
CABLE
In case the installation has a high delivery head, mount a good quality check valve in the
delivery line.
1
2
FUNNEL
JAR
1
2
FUNNEL
JAR
JAR
FUNNEL
21
Fig. 6(b) Fig. 6(c)
Fig. 6(a)
OMOW002A 16 2020.01