The motors are internally wired and pre-connected with the capacitor leads
Connect phase and neutral to the terminal board
ELECTRICAL CONNECTION
Key features
The motor houses shielded type Deep Groove Ball Bearings, pre-filled with grease, to take up the
radial and axial thrust loads
The rotors are dynamically balanced
Adequate motor surface area is provided for effective cooling
Energy efficient motor for low power consumption
To protect the motor from overload, Thermal Overload Protector (TOP) is provided in TRH, TMM,
TSH and TGH Series
Brass forged impellers
Stainless steel shaft for long life
In case of leak past the mechanical seal, a water slinger, assembled on the shaft and in the
space between the mechanical seal and front bearing, prevents water entry into the motor
To reduce friction, the stuffing box – gland assembly is replaced with a mechanical seal
OMMM001A 8 2020.01
To Next Page
Loading...
