Do’s Don’ts
Use the eye bolts provided on the motor body for lifting
/ lowering the set
Do not use the power cable for lifting / lowering the
pump
When not in use for a long period of time, run the pump
for a few minutes every week to prevent the pump from
getting jammed
Do not switch off pump while pumping sandy water.
Continue to run until clear water flows
Cut out the center portion of the rubber gaskets on the
pump flanges before installing pipes
Do not operate the pump at shut-off conditions to
prevent the pump set from getting overheated
OMOW001A 28 2020.01
To Next Page
Loading...
