9
HYDRO
MIDSIZE
5. Connect throttle/choke cables.
Kohler single cylinder and Kawasaki models:
These engines are equipped with a unitized
assembly which controls both throttle and choke
with a single cable.
a. Set throttle control up against detent at the fast
position.
b. Connect throttle cable to engine and pull up until
alignment holes in the engine control lever and
control plate line up. Tighten throttle cable
clamp.
c. Check to be sure choke adjusting screw is
contacting choke control lever. Adjust if neces-
sary.
Kawasaki 14 Hp
Kohler and Kawasaki 14 Hp
Vanguard: Attach throttle cable as shown. Route all
cables so they do not pinch or bind. They must move
freely to work properly
Kohler V-twin: Attach throttle(T) & choke(K) cables as
shown.
ASSEMBLY INSTRUCTIONS
Kawasaki 17 Hp throttle cable connection
To Next Page
Loading...
