24
HYDRO
MIDSIZE
VERSADECK
WHEEL MOTOR
LOW CUTTING
POSITION
WHEEL MOTOR
HIGH CUTTING
POSITION
CUTTER
DECK
POSITIO
NUMBER
OF
BLADE
SPACERS
NUMBER
OF
CASTER
SPACERS
HEIGHT
OF CUT
NUMBER
OF
CASTER
SPACERS
HEIGHT
OF CUT
1/4"
SIZE
1/2"
SIZE
9" CASTER
1/4"
SIZE
1/2"
SIZE
9" CASTER
1 0
0 1 2-1/8" 0 3 3-3/16"
1 1 2-3/16" 1 3 3-1/4"
0 2 2-1/4" 0 4 3-5/16"
2 0
1 2 2-7/8" 1 4 3-15/16"
0 3 2-15 /16" 0 5 4-1/16"
1 3 3" 1 5 4-3/16"
3 0
0 4 3-9/16" 1 4 4-3/16"
1 4 3-5/8" 0 5 4-3/8"
0 5 3-11 /16" 1 5 4-9/16"
When using the Versadeck with mulching blades:
a) NEVER place spacers between spindle and blade.
b) The setting combinations in this table are recommended. These provide a slight blade slope with the
front of the blade higher than the rear (opposite slope direction to that recommended for side discharge
decks - see illustration below).
c) For 8” casters, height of cut is essentially the same as shown above.
Î
FRONT
È
1/4" MAX
Ç
HEIGHT OF CUT - VERSADECK
To Next Page
Loading...
