10
BZT
2200D
Series
ENGINE OIL
Do not perform engine maintenance without the
engine off and PTO disengaged.
AFTER FIRST FIVE (5) HOURS
While the engine is warm:
1. Remove drain plug D and drain the crankcase.
Dispose of used oil in accordance with local
requirements.
2. Clean and replace the plug D.
3. Change oil filter F. See Engine Manual
4. Remove cap C and fill the crankcase with fresh
oil to the full mark on the dipstick. Do not overfill.
See engine manual for oil specifications.
DAILY
1. Check oil level with the dipstick.
2. If oil is needed, add fresh oil of proper viscosity
and grade. See engine manual for oil
specifications. Do not overfill.
3. Replace dipstick before starting engine.
PERIODIC OIL CHANGES
1. See engine manual for oil and filter change
intervals after the break-in period.
2. Follow instructions for first oil change, above.
FUEL FILTER
An in-line fuel filter S is located at the right side of the
engine. Inspect at every oil change to make sure fuel
filter is clean an unobstructed. Replace if dirty or
after 400 hours of use.
MAINTENANCE
To Next Page
Loading...