19
BZT
2200D
Series
BELT REPLACEMENT
Note: Always use Bunton replacement belts, not general purpose belts. Bunton belts are
specially designed for use on commercial mowers and will normally last longer.
ENGINE-CUTTERDECK (PTO) BELT
1. Set the cutterdeck in the lowest height-of-cut
position.
2. Attach a short extension to a 3/8" drive ratchet.
Insert the ratchet extension into the square hole
in the idler arm and use the ratchet to rotate the
idler assembly enough to remove the belt.
Remove the belt from the idlers and center
cutterdeck pulley. Push belt back under engine
deck.
3. Remove old belt from the machine.
4. Install a new belt by performing the these steps in
reverse order.
NOTE: If clutch and torque restraint are ever removed
for maintenance, make sure when reinstalling
carriage bolts securing torque restraint Q to
clutch R to put the carriage bolts in facing the
ground first through the clutch and then
through the torque restraint and secure them
with the nuts as shown.
To Next Page
Loading...