GB-26
RANSOMES PARKWAY 2250 PLUS
SAFETY AND OPERATORS MANUAL
8 ADJUSTMENTS
8.3 SEAT
(MSG20)
The seat can be adjusted for leg reach and back rest
angle to provide a comfortable position for operating the
machine.
1. FORE AND AFT ADJUSTMENT
To Adjust:
The position of the adjusting lever (B) is on the right
hand side of the seat below the seat cushion . By
pulling the lever away from the seat, the seat can be slid
backwards and forwards, when in the desired position
release the lever to locate in one of the pre set
positions.
2. BACK REST ADJUSTMENT
To Adjust:
The position of the release lever (A) is on the left
hand side of the seat. While sitting on the seat pull
the release lever upwards to release the back rest.
(The back rest is spring loaded to fold onto the seat
cushion.) Lean back to obtain the desired position
for the back rest and release the lever to locate in
one of the pre set positions.
3. WEIGHT ADJUSTMENT
To Adjust:
The position of the operator weight adjust lever (C) is
on the left hand side of the machine. To increase the
operator weight sitting slide the lever down while
sitting on the seat. To decrease the operator weight
setting pull the lever upwards.
NOTE:The seat is fitted with a microswitch to sense
operator presence. When the machine is fitted with a
ROPS frame or cab a lap belt is fitted and should be
worn at all times
To Next Page
Loading...
