GB-23
RANSOMES PARKWAY 2250 PLUS
SAFETY AND OPERATORS MANUAL
7 OPERATION
7.8 PUSHING THE MACHINE WITH THE ENGINE
STOPPED
1. To push, disengage the parking brake.
2. Turn screw (A) located on the underside of the
transmission pump 1 turn counterclockwise. Set
the steering wheel so that the rear wheels are
pointing straight ahead.
3. Remove the tower cover and turn the emergengy
brake valve( B) towards the parking brake/hour
meter side of the tower.
4. Turn the steering wheel to the left until resis-
tance can be detected. The machine is now
ready to push. If unable to move the machine
apply further pressure to the steering wheel.
Excessive force should never be used on
the steering wheel.If the rear wheels start to
turn too much force is being applied.
5. After pushing, return valve (B) and knob (A) to
their previous positions.
To Next Page
Loading...
