09-367 5 - 8 rev 12/98
section 5 SERVICE
WHEELS & TIRES
•
Use only factory recommended wheels and
tires.
•
Never use different sizes in any combination.
•
Maintain proper air pressure.
•
Do not load tires with ballast or use wheel
weights.
•
Tire sealer may be used.
•
Be sure dual wheels are installed correctly and
the tire pressures are correct.
(See instruction sheet for dual wheels #19-166)
• Duals must be checked for tightness every day
until they are seated in. Torque center bolt to 80
ft. lbs.
• Avoid close operating conditions with duals
installed.
• Check lug nuts for torque.... 85 ft lbs.
• Seal beads with Permatex Liquid Sealer.
Throttle Adjustment
Tension adjustment is made by simply tightening
the spring loaded friction washers on the throttle
lever. High and low idle speeds are obtained by
adjusting the linkage at the engine.
Engine Low idle High idle
Linamar 1400 rpm 3600 rpm
Kohler 1400 rpm 3600 rpm
Kubota gas 1400 rpm 3600 rpm
Kubota diesel 1600 rpm 3600 rpm
To Next Page
Loading...