2. Battery life time would be much less than 1 year.
TO USE THE PROJECTOR POWER ADAPTER
The unit comes with an adapter unit for using the projector for an extended period of time, such as
throughout the night.
To install the adapter:
Important!
Make sure that your household voltage is 230V! Otherwise your projection clock may be
damaged.
1. Connect the power adapter to a wall socket
2. Insert the adapter into the jack at the bottom of the clock
3. The projection clock will now start receiving the DCF time signal. After approximate 3 to 5 minutes, the
DCF time will be displayed.
4. If reception is not successful within approximately 7-10 minutes, the Projection clock will attempt to
receive the signal in the following hour.
Your Projection clock is now operational.
29
To Next Page
Loading...
