5
Installation Instructions
Caution: The top plate material of this appliance is Glass!
• In order to avoid dangerous situation arising from breakage
of glass, DO NOT apply heavy weight or strong impact on
glass top.
• DO NOT make any scratch at the bottom side of glass, it will
cause glass breakage while in use.
1. Remove aluminum tape affixed at controller cable of glass top,
do not leave it inside the appliance.
2. Connect cable connectors at left side of base tray to that at
bottom of glass top.
3. Align glass top’s openings with burners.
• Pay attention not to squeeze the cables in between glass
top and base tray.
• Pay attention not to place the cables near burners.
4. Align the glass top correctly.
• The burners and glass top’s openings should be aligned
properly.
• After aligning the glass top, push it towards the front and fix
it.
5. Fix the timer knob and control knobs.
Installation Procedures
To Next Page
