The Fire Beam firebeam - Commissioning Process

step three. commissioning
to commission the fire beam you must follow the simple procedure below
1. do NOT put up the reflector or COVER it if in place already!
2. power up the unit - you will see
then the screen will default to
3. access the menu system by pressing enter
4. scroll through the menus until you get to commissioning
5. enter commissioning and enter pre-alignment
(pre alignment is probably the most important part of commissioning)
6. you will see this screen
received signal
P= pre-alignment
signal power
receiver sensitivity
X (horizontal)
motor position
Y (vertical)
motor position

6