MAINTAINING YOUR SOLIDFLO
™
G2 PUMP:
Step 3
Remove Pump Faceplate
Remove the 4 screws securing the pump faceplate.
Step 4
Remove Impeller
Pull gently to separate the entire impeller assembly
from the motor housing.
Step 6
Reinstall Impeller
Press the impeller back into the motor housing.
Step 7
Reinstall Pump Faceplate
Place the pump faceplate back onto the motor
housing and secure with 4 screws.
Step 5
Clean Components
CLEAN with a cloth or small brush and some water or
a descaler if needed. When using a descaler be sure to
rinse components well before reassembling.
• Pump pre-lter cage
• Pump faceplate, o-ring and impeller
• Motor housing
thepondguy.com | 866-POND-HELP (766-3435)
6
To Next Page
Loading...
