The Pond Guy SolidFlo G2 - Important Information; Electrical Safety Warnings; Operational Safety Warnings; Pacemaker Warning

IMPORTANT INFORMATION:
Please read these instructions thoroughly before use. Failure to follow instructions may result in
equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, SolidFlo™ G2 Pump should be replaced.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the receptacle or
plug that prevents water from traveling along the cord in the direction of the receptacle.
• ALWAYS unplug the SolidFlo™ G2 Pump from power source when it is not in use, and before
installing, removing or servicing the SolidFlo™ G2 Pump components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat if
the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the SolidFlo™ G2 Pump plug in water or attempt to use a wet plug.
• The SolidFlo™ G2 Pump is NOT suitable for use in swimming pools, swimming ponds, or other
situations where bodily contact is made with the water.
Important – This unit is equipped with a permanent magnet. The magnetic eld may aect the
function of pacemakers.
CAUTION:
To reduce the risk of equipment damage or failure:
• DO NOT place SolidFlo™ G2 Pump near ammable or other dangerous materials or objects.
• DO NOT use the SolidFlo™ G2 Pump for uids other than water.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• ALWAYS operate the pump completely submerged for proper cooling.
• DO NOT operate during freezing conditions. Drain SolidFlo™ G2 Pump and store in a protected
location.
IMPORTANT:
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death resulting
from failure to follow safety precautions, misuse or abuse of equipment.
TECHNICAL SPECS :
MODEL POWER WATTAGE MAX FLOW
MAX HEAD
HEIGHT
PLUMBING SIZE
POWER CORD
LENGTH
SolidFlo™ G2 1250
120V / 60 Hz
45 Watts 1,200 GPH 8’
1” or 1¼” Kink Free Tubing
or 1½” Flexible PVC. Rubber
Coupler Required (not included)
20’
SolidFlo™ G2 2000 70 Watts 1,900 GPH 9.5’
SolidFlo™ G2 2650 95 Watts 2,500 GPH 11’
SolidFlo™ G2 3600 145 Watts 3,500 GPH 13’
thepondguy.com | 866-POND-HELP (766-3435)
2