The Pond Guy SolidFlo G2 - Maintaining Your SolidFlo G2 Pump; Maintenance Safety Warning; Cleaning the Pre-Filter; Cleaning the Impeller Assembly

Watch a video of the SolidFlo™ G2 Pump maintenance
online @ www.thepondguy.com/solidog2
MAINTAINING YOUR SOLIDFLO
™
G2 PUMP:
WARNING:
Before performing any maintenance, always unplug the SolidFlo™ G2 pump
from the power source.
CLEANING THE PREFILTER:
CLEANING THE IMPELLER:
Perform anytime there is a reduction in water ow.
REMOVE large debris from the pre-lter and discard. The use of a small brush or cloth
may be helpful.
CLEAN with a cloth or small brush and some water or a descaler if needed. When using
a descaler be sure to rinse components well before reassembling.
Tools Required:
• #2 Phillips Screwdriver
• Damp Cloth or Small Brush
• Descaler such as Pond Equipment Cleaner
Step 1
Remove Pump Pre-Filter Cage
Remove the 2 screws securing the pump pre-lter
using your #2 Phillips screwdriver.
Step 2
Remove Pump Pre-Filter Cage
Seperate the top and bottom of the intake cage and
gently lift out the pump.
15425 Chets Way | Armada, MI 48005
5