Theatrelight CUEMASTER II - User Manual

Configure lighting states on the first 72 channels by adjusting fader levels.

Emulate a two-preset desk using the Park function for cross-fades.

Perform dipless cross-fades between two scenes using CHANNELS and PARK masters.

Instantly set channel output to Full using Channel Flash keys.

Activate memory modification by entering a specific record code.

Clear all stored recordings using a 4-digit erase code.

Protect recordings by disabling the record function.

Clear the record buffer memory without affecting stored recordings.

Set up and store lighting states as manual scenes on Scenemasters.

Record scenes without live output for assignment to Scenemasters.

Playback recorded manual scenes, controlled by Scene LEDs and Masters.

Instantly recall manual scene levels via flash keys for live playback.

Convert manual scenes to fade-scenes for timed playback.

Play back fade-scenes using timed fades, allowing cross-fades between states.

Halt or freeze a fade in progress using the Hold key.

Record sequences of lighting steps as chases on Submasters.

Playback recorded chases forward or in reverse at controlled speeds.

Instantly add chase levels via flash keys, overriding other output.

Control chase direction and stop playback using the Chase Reverse key.

Record sequences of cues as shows, assigning them to Submasters.

Execute recorded shows step-by-step or automatically.

Modify recorded fade times for individual cues within a show.

Adjust playback levels of individual cues within a show while live.

Remove specific cues from a recorded show.

Add new cues into a show at specified positions.

View channels and links for the next cue in a show without live playback.

View levels of recorded manual scenes or fade-scenes.

Step through chase steps or show cues in sequence for preview.

View channels stored under the Park Master without affecting live output.

Set channel flash keys for push-on/push-off operation for effects.

Configure Scenemaster flash keys for solo auto-cancel or latch modes.

Prevent unwanted flashes or blackouts by disabling all flash functions.

Overview of the DMX-Link module for patching and backup.

View and verify the one-to-one patch list settings.

Set the patch list to zero, disconnecting all dimmers from channels.

Test and flash channels and their patched dimmers for correct operation.

Test and flash individual dimmers for correct operation.

Set the test level to specific percentages from Off to Full.

Connect and set up an external LCD monitor for desk information.

Navigate through different information pages on the LCD display.

Save the entire Cuemaster II memory to an SD card for backup.

Restore Cuemaster II memory from a saved SD card volume.

Connect a PC compatible parallel printer to the Cuemaster II.

Print recorded levels, fade times, cues, links, and patch status.

Cancel an ongoing print job.