CUEMASTER II OPERATION 81
TESTING ALL CHANNELS OR DIMMERS
You can test all Channels or Dimmers to the level of the Channels Master fader as follows:
1 Set the Channels Master Fader to Off. This is important as otherwise the entire lighting rig may be suddenly turned on.
2 Press [CL] to clear the Channel display, then hold [TS] and CH] to test all Channels, or [TS] and [DM] to test all dimmers.
3 Slowly raise the Channels Master Fader to view all Channels or Dimmers at the master level.
4 Press [TS] or [CL] to stop the test.
CANCELLING TEST MODE
Since Test mode over-rides all other channel or dimmer levels, you must cancel Test mode to avoid leaving lights up on stage:
> Press the [CL] key.
§ You can also edit the Patch list while live testing either channels or dimmers—see page 75.
To Next Page
Loading...