Theatrelight CUEMASTER II - Copying a Scene Blind; Transferring a Scene to Another Page; Deleting a Scene; Over-Writing a Scene

CUEMASTER II OPERATION 41
COPYING A SCENE BLIND
You can copy a Manual Scene or Fade-Scene to any other Scenemaster without it showing on stage:
1 Hold [RECORD] and [REC STACK] (the All key), then press the Flash key of the Master to be copied.
2 Hold [RECORD], then press the Flash key above the new Master to assign the recording.
The new Scene is always recorded as a Manual Scene. If you copy a Fade-Scene from the bottom preset to another master on the
bottom preset, you will need to change the copied Scene back to a Fade-Scene. Then, you will find it has the same auto fade time as the
original Fade-Scene. The original recording is not changed by this operation. The first operation using the Record Stack key copies the
recorded levels and fade time of the Scenemaster to the Record Buffer memory, a useful technique which can also be applied to stacking
a number of Scenes, Chases, and Shows as described later.
TRANSFERRING A SCENE TO ANOTHER PAGE
You can also copy a Scene to any other page as follows:
1 Hold [RECORD] and [REC STACK], then press the Flash key of the Scene to be copied.
2 Press [PAGE UP] or [PAGE DOWN] to move to another page.
3 Hold [RECORD], then press the Flash key above the new Scenemaster or Submaster to assign the recording.
Again, the new Scene is recorded as a Manual Scene, and it is on the bottom preset and changed to a Fade-Scene, it will have the same
auto fade time as the original Fade-Scene.
DELETING A SCENE
You can delete any Manual Scene or Fade-Scene as follows:
> Hold [RECORD] and [DELETE], then press the Flash key of the Scene to be deleted. A short Mimic flash indicates the
Scene has been deleted, and the LED above the Scenemaster is turned off.
OVER-WRITING A SCENE
You can over-write any Manual Scene or Fade-Scene with a new Scene as follows:
1 Set up a new Scene using the Channel faders, or by using the Up and Down keys, and set the fade time if needed for an
auto Fade-Scene.
2 Press [RECORD] to record the levels.
3 Hold [RECORD], and press the Flash key of the old Scene. Wait for a long Mimic flash, then press it again.
The long Mimic flash after the first press of the Scenemaster Flash key is a warning that the Scenemaster holds a recorded Scene. The
short Mimic flash on the second press indicates the new Scene has been assigned, and the old Scene over-written.