CUEMASTER II OPERATION 79
TEST AND FLASH MODES
CHANNEL TEST AND FLASH MODES
You can test and flash on or off each channel (and its patched dimmers) to check for correct operation. The Test LED lights as a warning
that a channel level may have been over-ridden. To test all Channels in succession:
1 Press [CH], then [TS] repeatedly. Each channel is turned on at Full in order live on stage.
2 Press the [TD] key to go back a channel, press the [TS] key to go forward again.
3 Press [TS] for 2 seconds then release for an auto test forward at 1 second intervals.
4 To pause the auto test, hold the [TP] key.
5 To temporarily reverse the direction of the auto test, hold the [TD] key.
6 Press [TS] or [CL] to stop the test.
To test or flash any particular channel for example Channel 12:
> Press [CH] [1] [2], then [TS]. Then press [0], then [F] repeatedly: Channel 12 will flash off and on.
DIMMER TEST AND FLASH MODES
You can test and flash on or off each dimmer for correct operation. The Test LED lights as a warning that a dimmer level may have been
over-ridden using this mode. To test all Dimmers in succession:
1 Press [DM], then [TS] repeatedly. Each dimmer is turned on at Full in order live on stage.
2 Press the [TD] key to go back a dimmer, press the [TS] key to go forward again.
3 Press [TS] for 2 seconds then release for an auto test forward at 1 second intervals.
4 To pause the auto test, hold the [TP] key.
5 To temporarily reverse the direction of the auto test, hold the [TD] key.
6 Press [TS] or [CL] to stop the test.
To test or flash any particular dimmer for example Dimmer 12:
> Press [DM] [1] [2], then [TS]. Then press [0], then [F] repeatedly: Dimmer 12 will flash off and on. Press [TS] or [CL] to
stop the test.
CHANGING TEST LEVEL
You can set the Test level to any 10% value including Off and Full as follows:
> Press [CL] to clear the Channel display, then hold [TS] and [AT] and press a number: 0, 1 through F. This test level is
reset to Full if the desk is turned off or if the memory is erased.
To Next Page
Loading...