CUEMASTER II OPERATION 11
M CHANNEL DISPLAY l shows the currently selected channel number for patch editing, channel flash, level read, and test modes. The
Channel display is also used when programming the split between the total of 288 channels from the two DMX inputs. When Scenes
are edited this display shows S. to indicate an addressed Backup Scene number.
DIMMER DISPLAY shows the currently selected dimmer number for patch editing, dimmer flash, level read, and test modes. When
Scenes are edited this shows an addressed Backup Scene channel number.
DIMMER END POINT indicates the last dimmer patched to the current channel when reading Patch List levels.
LEVEL DISPLAY shows channels, dimmers, and test levels as a percentage, from 0 to F (Full). If both Channel and Dimmer displays
are showing a valid number with the Edit LED on, then the level shown is the recorded Patch List level. The Level display also shows
live channel or dimmer output levels, and test levels in both Channel and Dimmer Test modes. 1
EDIT LED indicates a valid Patch edit state. This LED is a warning that any level changes to dimmer levels (in Patch Edit mode) will
be immediately written to memory.
TEST LED shows that a channel or dimmer level has been modified by a Test operation.
N CL KEY (Clear Key)is use1d to clear the Channel and Dimmer number display, and to reset Test mode.
CH KEY (Channel Key) is used to enter channel numbers for Patch editing, reading channel levels, and testing channels.
DM KEY (Dimmer Key is used to enter enter dimmer numbers for Patch editing, reading dimmer levels, and testing dimmers.
AT KEY sets Patch levels, and interrogates channel and dimmer levels, and Patch List dimmer levels.
NUMBER KEYS are used for entry of Channel and Dimmer numbers, and levels.
0 KEY (Zero Key) sets levels off, and with the DIM and AT keys sets dimmers of the current Patch List to zero.
F KEY (Full Key) sets levels to full, and with the DIM and AT keys sets all dimmers of the Patch List as a One to One patch.
TS KEY (Test Key) allows testing of channels or dimmers. Test direction may be changed using [TD], the test down key.
TP KEY (Test Pause) is used to pause auto test mode.
TD KEY (Test Down Key) is used for testing channels and dimmers in reverse direction.
5 KEY (Screen Up key) increments the current Screen page on the LCD display.
6 KEY (Screen Down key) decrements the current Screen page on the LCD display.
O DESK LIGHT SOCKETS are provided for plug-in goose-neck working lights.
To Next Page
Loading...