A. Add a Stack Target Volume
From the figure above, click Add to access the stackable target device configuration
page. Please refer to the figure below:
With the added stack target you could “Enable” or “Disable” now or later per usage
needed.
Next, input the target IP address of the stackable device and click the Discovery
button. The system will list available target volumes from the inputted IP address.
Once IP with volume have been set, you may need to input a valid user name and
password to validate your access rights. If there is no user name and password
needed to access target volume, then leave it blank.
To Next Page
Loading...
Need help?
General
