Click Apply to save your changes.
B. Activate a Stack Target
After your settings have been applied, the system will bring you back to Stack
Target List window as shown below. There is one stack target device has been
attached into this stack master.
With this newly attached stack target device, you will see the information displayed
and also several options you can choose.
In general, if attached stack target device has been used by another
N5200PRO/1U4500/N5500/N8800 series as stack target volume, then the Format
item will be display and system will recognize it straight away and display its
capacity. Otherwise, the Format item will be available and the Capacity and
Status items will show as “N/A” and “Unknown file system” respectively.
Next, click Format to proceed with formatting.
To Next Page
Loading...
Need help?
General
