Safety Warnings
For your safety, please read and follow the following safety warnings:
Read this manual thoroughly before attempting to set up your N8800SAS.
Your N8800SAS is a complicated electronic device. DO NOT attempt to repair
it under any circumstances. In the case of malfunction, turn off the power
immediately and have it repaired at a qualified service center. Contact your
vendor for details.
DO NOT allow anything to rest on the power cord and DO NOT place the
power cord in an area where it can be stepped on. Carefully place connecting
cables to avoid stepping or tripping on them.
Your N8800SAS can operate normally under temperatures between 0°C and
40°C, with relative humidity of 20% – 85%. Using the N8800SAS under
extreme environmental conditions could damage the unit.
Ensure that the N8800SAS is provided with the correct supply voltage (AC
100V ~ 240V, 50/60 Hz, 3A). Plugging the N8800SAS to an incorrect power
source could damage the unit.
Do NOT expose the N8800SAS to dampness, dust, or corrosive liquids.
Do NOT place the N8800SAS on any uneven surfaces.
DO NOT place the N8800SAS in direct sunlight or expose it to other heat
sources.
DO NOT use chemicals or aerosols to clean the N8800SAS. Unplug the power
cord and all connected cables before cleaning.
DO NOT place any objects on the N8800SAS or obstruct its ventilation slots
to avoid overheating the unit.
Keep packaging out of the reach of children.
If disposing of the device, please follow your local regulations for the safe
disposal of electronic products to protect the environment.
3
To Next Page
Loading...
Need help?
General