Themis TS-500 - LED and Beeper

23
3-8 LED and Beeper
Power on alert: After power-on the imager will generate an alert signal to indicate a successful self-test.
LED indication: After each successful reading, the LED above the imager will light up to indicate a good
barcode reading.
Beeper indication: After each successful reading, the imager will beep to indicate a good barcode
reading, and its beep tone duration is adjustable.
Beep tone duration: This parameter can be adjusted for a good reading upon favorite usage.
Volume of beeper: This parameter can be adjusted for different level of the volume of the beeper.
Multiple-scan setting
Single-scan setting
Option barcode Option Alpha. entry
Power on alert
Disable 00
Enable 01*
*
LED indication
Disable 00
Enable 01*
*
Beeper indication
Disable 00
Enable 01*
*
Beep tone duration
01-09 (10 ms )
01-09
05*
*
Volume of beeper
Low 00
Middle 01
High 02*
*