28
Note: The instruction of calibrating the aimer in vertical centering direction.
1. Scan the barcode on this page. The imager will give three musical short beeps to indicate entering
calibration mode.
2. Press the trigger of the imager while maintaining the distance of about 15cm between the exit
window of the imager and this paper. After a few seconds, the imager will give three short beeps to
indicate a successful calibration, or a long beep to indicate a failed calibration.
3. If the calibration is failed in step 2, please repeat the steps 1-2. If it is not succeed after a multiple
times of calibration, please contact your local dealer or the manufacturer for further instruction.
To Next Page
Loading...
