POOL+ MANAGER App A2 - User Manual v1.0 12
6. INSTALLER MENU
The Installer Setup is where you will go to enter all the equipment that is installed on the Pool/Spa system
and can have its settings changed in the Menu functions or via the App.
6.
INSTALLER
MENU
Under the Installer Menu there is a range of options to choose from. These are:
1. Appliances
2. Pump
3. Lights
4. Heating
5. Spa
6. Heat Demand
7. Pump Call
8. Water Feature
9. Temperature Sensor
10. Expansion Unit
11. Set Time
12. WIFI
13. Factory
14. About
Use the
or
buttons to toggle through the list of menu options. When the option you
want is displayed on the screen, press the Enter button.
6.1
APPLIANCES
Appliances can be allocated on up 8 power sockets, 4 valves and 1 VF contact.
Socket 1-2, Valves 1-4, and the VF Contact are all located on the master controller.
Sockets 3, 4, & 5 are located on Expansion Unit 1.
These sockets are only available for selection if the expansion unit is there and has been enabled.
Sockets 6, 7, & 8 are located on Expansion Unit 2.
These sockets are only available for selection if the expansion unit is there and has been enabled.
The list of appliances available to choose from are listed below:
Sockets
Sanitiser
Filter Pump
Cleaning Pump
Blower
Pool Light
Spa Light
Garden Light
Water Feature
Solar Pump
Other
Always On
Jet Pump
None
Valves
Pool/Spa
Filter Pump
In Floor cleaning
Water Feature
None
None
VF Contact
Gas Heater
Heat Pump
To Next Page
Loading...