Theralux POOL+ MANAGER A2 APP - FILTER TIME CONFIGURATION; Setting Filtration Cycles

POOL+ MANAGER App A2 - User Manual v1.0 8
1.
FILTER TIMES
You have the option to choose up to 4 different Filtration Times.
When you select the FILTER TIMES menu option, the screen will display:
FILTER ON
TIME 1 OFF
When you select ON and press ENTER the screen will display:
FILTER XX:XX
TIME 1 ON XX:XX
Adjust the start time and end time for the required filter cycle. The circulation pump
will run between these times for filtration purposes.
Once you have set the first filter time, you will then be asked to select a pump speed
for the first filter cycle.
Note: This will only be displayed if you have installed a Multi Speed Pump through the
Installer Setup (6.2). You won’t be asked for a pump speed if Single Speed pump was
selected in the Installer Setup (6.2).
This will be displayed as:
FILTER TIME 1
SPEED 1, (2,3, or 4 can be selected, depending on pump).
Once you have selected a speed for the first Filter Cycle, the option for a second filter
cycle will be displayed:
FILTER ON
TIME 2 OFF
Set and adjust as with Filter Time 1 or if not required then set the timer to OFF.
Repeat the above steps for Filter Time 3 and 4.
Note: You can run different pump speeds in the separate filter times.
 Filter cycle 1 may run at speed 4, filter cycle at speed 2, filter cycle 3 at speed
1, and filter cycle 4 at speed 4.
 For example:
Filter Time 1: 8.00 – 9.00 at speed 4.
Filter Time 2: 9.00 – 15.00 at speed 2.
Filter Time 3: 15.00 – 16.00 at speed 4.