Transmitter Features
Wire Stand – Allows you to stand the transmitter on tabletop or it can be
reversed and used as a hanger.
Battery Compartment – holds 2 AAA batteries.
Sensor Socket Hole: plug in for stainless steel probe sensor.
Soft rubber
sleeve
Sensor
socket hole
TX indication led
Battery Compartment
ºF/ºC/
Wire Stand
LCD (Liquid Crystal Display)
Installing Batteries
Open the battery compartment of the receiver and insert two “AAA” batteries with
correct polarity. Open the battery compartment of the transmitter and insert two
“AAA” batteries with correct polarity.
Turn On/Off Unit
Press and hold F/ C button on the receiver for 2 seconds to turn on/off the
receiver.
º º /
Press ºF/ºC/ button on the transmitter for 2 seconds to turn on/off the
transmitter.
and hold
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing facility.
Usually you do NOT need to re-synchronize or re-pair the units. You just plug in the
probes, insert batteries, turn on the receiver and the transmitter and wait for a few
seconds, you will see the temperatures shown on both receiver and transmitter
and the units are ready for use.
However, in some unusual cases, the transmitter and receiver are no longer paired,
then you may need to re-synchronize them by following the below steps:
a. Insert the stainless steel probes into the corresponding ports in the transmitter.
b. Turn on the transmitter by pressing and holding the ºF/ºC button for 2
seconds. The transmitter will show the current temperatures on its LCD display.
/
c. Turn on the receiver by pressing and holding the F/ C button for 2 seconds.º º /
d. Press and hold Mode button on receiver for 2 seconds to enter the synchroniza-
tion mode which will last for 60 seconds. The display shows “---” and it is flashing.
LCD
Probe Temp Reading
Probe Temp
Setting
Taste level
Meat type
Timer
Thermometer Mode Timer Mode
Buttons
ºF/ºC/
Press once to select temperature readings in Celsius or Fahrenheit.
– Press and hold for 2 seconds to turn the transmitter ON or OFF.
-5--4-
e. Wait for a moment until the temperature reading shows on the receiver display,
it means the synchronization/Pairing is complete. Your professional remote
Transmission frequency: 433 Mhz
Maximum transmit power: 8 mW
ENEN
To Next Page
Loading...
