Count up
1. Press MODE to select timer mode. The upper display will show a small TIMER
and 0:00.
2. Press START/STOP button to start count up. The “ ” will blink for every
second.
3. To stop the count up process, press START/STOP button. The “ ” becomes
solid.
4. Press CLEAR button to clear the setting back to 0:00.
Clean the stainless steel probe and dry thoroughly after each and every use.
Not Intended for using by Persons ages 12 and Under.
Keep the stainless steel probe sensor and wire away from children.
Cautions
Always wear a heat resistant glove to touch the stainless steel probe sensor or
wire during or just after cooking. Do not touch with bare hands.
Do not expose the plug of the stainless steel probe or the plug in hole of the
transmitter to water or any liquid. This will result in a bad connection and faulty
readings.
Do not expose the receiver or transmitter to direct heat or surface.
Do not use stainless steel probe in microwave oven.
Cleaning
Always wear heat resistant glove to touch the stainless steel probe sensor or
wire during or just after cooking. Do not touch with bare hands.
Keep the stainless steel probe sensor and wire away from children.
Wash the metal probe tip with hot soapy water and dry thoroughly. Do not
immerse the probe in water while cleaning.
Wipe the transmitter and receiver with damp cloth. Do not immerse either in
water.
Do not use the receiver or transmitter in the rain. They are not waterproof.
Do not immerse the probe or wire in water. use a damp, soapy cloth to clean.
Using the Timer
Count down
1. Press MODE to select timer mode. The upper display will show a small TIMER
and 0:00. Press MEAT to switch between hour/minute timer to a minute/second
timer and back.
2. Press HR and MIN button to set the timer. Press START/STOP button to
countdown. “ ” will blink for every second.
start
3. To stop the countdown process, press START/STOP button. The “ ” becomes
solid.
4. Press HR & MIN buttons together to clear the setting back to 0:00.
Note: The minimum setting for the timer is 1 minute. When the timer counts down
below 1 hour 1:00, the display will change to 59'59” to indicate, 59 minutes 59
seconds. The seconds will be shown counting down then. When the countdown
reaches 0'00” the timer starts counting up and it will beep for 60 seconds. The
timer and “ ” will blink. Press the START/STOP button to stop the beeping.
When the count up reaches 23:59:59 (59 seconds are not displayed) the display
will turn to 0:00, the unit beeps and “ ” will blink for 60 seconds.
Helpful Hints
If the receiver and / or the transmitter display LLL or HHH instead of
temperature, wait for probe to reach room temperature. If LLL or HHH is still
displayed or you get a false temperature, squeeze the probe jacks harder into
the transmitter and twist them back and forth so they make good contact. If the
problem still persists it is likely the internal probe wire has shorted out either
through moisture or heat damage.
the probe
-9--8-
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into contact with flames.
ENEN
If the temperature displayed seems to read too high or the temperature seems
to increase too quickly, check to make sure the probe tip is not poking through
the food to outside. Reposition the probe tip in the center of the thickest part of
food. Avoid touching bone or heavy fat areas.
Within the warranty period, please contact our customer service below
and we will send you a replacement probe at no charge.
To Next Page
Loading...
