To Next PageTo Next Page
Need help?Do you have a question about the Therma-Stor 4021400 and is the answer not in the manual?
General| Brand | Therma-Stor |
|---|---|
| Model | 4021400 |
| Category | Dehumidifier |
| Language | English |
Discusses placement options and environmental considerations for optimal dehumidifier performance.
Explains using ducting for improved dehumidification in various room and area configurations.
Outlines power needs, circuit specs, and gravity drainage procedures for the unit.
Provides guidelines on duct sizing and branching for effective dehumidification and airflow.
Explains how to set the humidity control and how RH levels are affected by temperature.
Describes the function of the blower switch for continuous air circulation.
Details the types of air filters, cleaning, and replacement recommendations for optimal performance.
Instructs users to read the warranty certificate and contact the factory for repair authorization.
Provides a technical overview of the refrigeration system and its components like evaporator and compressor.
Lists common issues like no dehumidification or compressor cycling, with potential causes and solutions.
Identifies causes for frosted coils and reduced capacity, including thermostat, charge, and filter issues.
Outlines the procedure for accurately weighing in refrigerant charge during service.
Provides step-by-step instructions for removing and replacing the blower assembly.
Details how to test compressor motor circuits for continuity and potential defects using an ohmmeter.
Guides through replacing a compressor that has failed due to overheating and sludge.
Explains the process for replacing a compressor that has not experienced a burn-out failure.
Describes the operation of the humidity control and the defrost thermostat.
Details how the condensate pump activates and pumps water when the reservoir level rises.
Presents the electrical schematic illustrating the connections of various components in the dehumidifier.
Lists all available replacement parts for the Santa Fe Classic dehumidifier with their part numbers.
Illustrates the physical location of key components within the Santa Fe Classic unit.
Provides step-by-step instructions for installing an optional remote humidity control unit.
Details the process for installing the optional condensate pump kit, including hose routing and connections.
Explains how to install the ductable inlet for drawing air from a remote location.
Details the steps for mounting the exhaust collar for ducting the unit's output.
Provides instructions for installing the muffler kit to reduce operational noise.
Guides on the correct orientation and method for installing the foam and pleated air filters.
Outlines the three-year and five-year warranty periods for the product and its components.
Details what voids the warranty and the customer's responsibilities for claims and service.
Specifies limitations on Therma-Stor's liability and governing law and venue for disputes.
