To Next PageTo Next Page
Need help?Do you have a question about the Therma-Stor Santa Fe and is the answer not in the manual?
General| Brand | Therma-Stor |
|---|---|
| Model | Santa Fe |
| Category | Dehumidifier |
| Language | English |
Describes various indoor installation locations and essential cautions.
Simple installation placing unit in humid area with adequate air flow clearance.
Using ducts to improve dehumidification in large or high-ceiling humid areas.
Installing unit in an adjacent room with ducting to the humid area.
Remote installation with ducting for outlet, drawing air from unit's room.
Remote installation for pressurizing room, drawing air from humid area into unit.
Details power connection, circuit requirements, and GFCI for wet areas.
Instructions for routing the drain hose and extending it with PVC pipe.
Guidelines for duct sizing and branching for effective dehumidification.
Explains how to set the humidity control dial and its limitations.
Describes the function of the fan switch for continuous blower operation.
Details the types of filters and their maintenance schedule.
Instructions for periodic lubrication of the blower motor bearings.
Information on warranty claims and contacting the factory.
Explains the refrigeration system cycle and components.
Lists common problems and their potential causes and solutions.
Procedures for accurately recharging the system with refrigerant.
Step-by-step instructions for replacing the blower motor assembly.
Detailed procedures for compressor and capacitor diagnosis and replacement.
Tests to diagnose compressor electrical circuit issues.
Detailed procedure for replacing a burned out compressor, including cleanup.
Procedure for replacing a compressor that is not burned out.
Explains the function and operation of the humidity control switch.
Describes the defrost thermostat's role in preventing evaporator coil icing.
Explains how the condensate pump operates to remove water.
