EX-TRAFIRE
®
75SD
Operator Manual, Revision T-56
SAFETY
The symbol shown in this section means: !Caution! !Beware!
¡There are possible hazards with this procedure!
When you find this symbol in the manual or on the system,
be cautious, and follow the related instructions to avoid the
hazard�
Follow the safety instructions to avoid danger�
Only qualified persons should install, operate, maintain and
repair the system�
Keep out of reach of children�
Prolonged exposure to noise from plasma cutting/gouging
can cause hearing damage�
• Use approved ear protection when operating the
plasma system�
• Warn others about the dangers of noise�
NOISE CAN DAMAGE HEARING
!CAUTION!
Arc rays from the cutting/gouging processes produce intense
visible and invisible rays that can burn eyes and skin�
Use protective clothing made from durable, flame-resistant
material, appropriate footwear and hand protection�
• Use face protection (welding helmet or shield) with
the correct shade of filter lens fitted to protect your
eyes and face (see Table 1�1)�
• Warn people of the dangers of looking at the arc, use
signs to warn/inform�
PLASMA ARC RAYS CAN BURN EYES AND SKIN
Flying sparks are created during the metal cutting/gouging
processes; the area around the cutting process should be kept
free from flammables�
• Use face shield/safety glasses with side protection�
• Wear flame resistant clothing, footwear and hand
protection�
• Use earplugs/defenders that are flame resistant to
prevent sparks entering the ear and to reduce the
noise level�
FLYING SPARKS (ARC SPRAY) CAN
CAUSE INJURY, FIRE OR EXPLOSION
1
2
CAUTION!
READOPERATOR’SMANUAL
To Next Page
Loading...