PAGE 5
To Remove and Clean Filters
1. Intake must be in the raised position to clean.
2. Turn Off the blower.
3. Remove filters by pushing top of filters with thumbs
until they release from frame. Begin by removing
center filter(s), then remove outside filters.
CARE AND CLEANING
• Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.
• Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.
• After cleaning, place filters in their proper positions before using the Cook‘n’Vent
®
.
The cleaners recommended in the Care and Cleaning Table (pg. 6) indicate a type and do not
constitute an endorsement. Use all products according to package directions.
The efficiency of the Cook‘n’Vent
®
downdraft ventila-
tion system depends on the cleanliness of the intake
and filters. The frequency of cleaning depends on the
amount and type of cooking.
• Do not use the ventilating system without the fil-
ters in place or with grease-laden filters or surfaces.
4. Wash filters with soap and warm water, or in a dish-
washer
5. Wipe up any accumulated grease or food on the
Intake. Use a general household degreaser spray or
cleaner. Rinse and dry.
To Re-Assemble the Filters
1. Insert bottom edge of filter into ledge at bottom of
frame intake.
2. Push top portion of filter into top frame of intake
until it snaps into place.
3. Do the same for each filter. Begin with outside fil-
ters, then center filters.
Care and Cleaning Tip
Order of Filter Removal Order of Filter Replacement
30” and 36” UCV Filters 45” UCV Filters
2 1 2 2 1 1 2 1 2 1 1 2 2 1
30” and 36” UCV Filters 45” UCV Filters
CAUTION:
Do not touch filters
until they have suf-
ficiently cooled off.
To Next Page
Loading...
Need help?
General
