i
INTRODUCTION
Read and understand this entire Service Manual and your employer’s
safety practices before installing, operating, or servicing the equipment.
While the information contained in this Service Manual represents our
best judgement, Thermal Dynamics Corporation assumes no liability
for its use.
Thermal Arc Models 400 S, GMS & GTS CC/TIG Welder
Service Manual Number 0-2509
Published by:
Thermal Dynamics Corporation
Industrial Park No. 2
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
Copyright 1997 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written
permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any
party for any loss or damage caused by any error or omission in this
Service Manual, whether such error results from negligence, accident, or
any other cause.
Printed in the United States of America
April 25, 1997
To Next Page